Vertical Kayak Storage Rack Wall Mount #00774

Vertical Kayak Storage Rack Wall Mount #00774

Tech Team has developed a totally new approach to solving this problem. The Tech Team #767 agricultural gate wheel uses a 16” diameter flat free wheel and tire assembly that rides on a 5/8” diameter axel and two sets of ball bearings. It will never go flat and always rides smoothly, even over uneven surfaces. In addition, due to the fact that it is flat free, there is never a worry about having to bring a hand pump or compressor to fill the tire. The unit is designed for agricultural and industrial type use with a ¼” thick/ 6mm mounting plate that uses three 3/8”/10mm diameter saddle clamps so that it can be securely attached to 1 5/8” – 2” diameter tubular steel agricultural gates. In addition, it is designed so that the wheel can ride as close as 1” below the bottom of the gate or up to 10” below, giving it a wide range of applications. Typical installation takes less than 15 minutes and can be done with a simple open-end wrench.

 

 

Description

Vertical Kayak Storage Rack Wall Mount #00774

Item Listing

Once again, Tech Team brings you a great kayak, SUP, and paddle board storage option. The rack is designed to contain multiple SUP’s or paddle boards, and one or two kayaks in a vertical orientation. All Tech Team’s other kayak storage racks are designed for horizontal, against the wall installation. Sometimes you have limited horizontal wall space, but enough vertical space to make vertical storage an option. This is where the 774 Vertical Rack and Organizer comes into play. Since storing a boat in this rack does not involve lifting the entire boat and hefting it onto support members, one person need only be able to set one end in place, and then gradually elevate the balance of the boat and lash it into place. The rack is constructed from heavy duty welded steel with a powder coat finish and is designed to provide useful service for many years. In most residential construction, the studs inside the wall (these are the vertical members to which the drywall is anchored) are 2 x 4 or 2 x 6 pieces of lumber with a vertical orientation. Each one of these is 1.5 wide. Since the 774 rack is not supporting any weight, it is appropriate to anchor the sections of the rack to the studs. In order to make this process easier the mounting holes have been set on exact 16 centers so they will align with the wall studs. Installation is a very simple process.

 

INSTRUCTIONS